 
I am supposed to be designing some new kits for the up and coming show at Jeff's Shed that Rae and I do each year. But, I don't like stocking the stand with my old designs so I thought I would post one of the scarves up for anyone who wants to have a go. This one I like because it enables me to showcase Rae's lovely fabric pieces and offcuts rather than having to use a whole piece of silk tissue the length of the scarf.
Enjoy.
- Place      sheet of bubble wrap bubble side up on a table covered with towels. 
- Place      silk fabric pieces on the bubble wrap where you want them to go. I placed      a piece of fabric each end to become a fringe. When the merino felts, it      gathers up the silk into a lovely flowing fringe. I left 20cm of the      fabric out of the scarf to become the fringe. I also ripped up pieces of      the silk and placed bands of it along the length of the bubble wrap, not      placing the merino on the silk but overlapping it a little so the silk      would catch.
- Hold      the merino loosely in one hand      and using all your fingers against the fat part of your palm pull away a      layer of merino fibres and lay them on your bubble wrap, starting 15cm      from one end. I pull away a sheer or thin layer and over lap them slightly      fibres all pointing north south along the bubble wrap until I have a      rectangle 30cm x180cm. Pull away another sheer layer and overlap them east      west over the top of your first layer. The amount of merino in this kit is      exactly right for the scarf so make sure you pull away less rather than      more (40-50 grams). Anymore and the scarf would be too thick.
Now is the time to lay on any decorative elements you might want to add. Silk fabrics, yarns, wools, other colours are all good! To make swirls or circles, pull away a small amount of fibre and roll it into a snake using slightly wet hands. (You are felting it) Lay the swirl down in the position you want.  To help hold it in position place a very sheer layer of merino over it. If you have silk hankies , separate the layers and lay them down on the merino. (One hankie will separate into several layers, I like to distort them rather than keep them square.) 
- Lay      the nylon net over your scarf and pour warm water over it patting the      surface gently to encourage the water to soak in. The water stays mostly      on the bubble wrap so be liberal with it. All the fibres need to be wet.      Rub over the net with a bar of low suds soap. Remove the net carefully and place your hand in a plastic      shopping bag and softly rub the surface of the  scarf for about five      minutes.  
-  Check the edges of the scarf and if you don’t like      the irregular edges, fold them back over. I usually don’t worry and tend      to give the scarf a trim with scissors a little further on in the felting      process. 
- Continue      to rub the scarf with your hand in the bag for another 5 minutes. 
- Now      roll the bubble wrap and scarf into a tight sausage and tie some sting      around each end to hold it. It looks like a giant bon bon. Now without      pressing hard just roll it back and forth 150 times. You can do this in      front of the tv or get the kids to do it! Unroll it carefully. You should      be able to see  the fibres are starting to interlock and move through the weave of the fabric. The silk      will start to crinkle up as the fibres  travel through it and begin to shrink. Carefully      turn the scarf over and straighten, reroll the bubble wrap and roll again      150 times. Unroll.
- If      you feel the scarf is shrinking too much in one direction, Rub it by hand      up and down the way you want it to shink.  Its probably time to cut away any daggy bits      from the overall shape.
-  I like to roll the bubble wrap length      wise as well into a long sausage and roll. It helps keep the scarf’s shape.      
- Roll,      and keep turning the scarf over on the bubble wrap after every 100 rolls
- By      now you should be able to see the migration of surface fibres through to      the back, some to the front, general shrinkage of the scarf and not be      able to pinch fibres away from the surface without them breaking. Generally though, Your scarf is felted when it has shrunk by a third. Or, do a 'pinch test'. Pinch some fibres on the surface and pull, if they come up as a pyramid- it's not felted. If they come up like a tree trunk and begin to break- they are felted. To speed felting up, you can      apply warm/ hot water, and pick the scarf up and drop it back down to the      bubble wrap several times- shocking the fibres. Beware with this      technique, felting happens fast but it can cause the scarf to loose its      shape.
- There      are many techniques for felting, every felt maker swears by their own      technique, so don’t feel obliged to follow mine. It works for me though.      When you feel the scarf is felted enough and shrunk      enough, rinse it out, pull it into shape and hang to dry. I iron my scarf      on a medium setting.
 
 
 
You have almost persuaded methat your method of felting is not too strenuous for my arthritic joints. Cheers, Robin
ReplyDelete